How do I clean my sparkling water maker? This is a question of most concern to any person with a countertop unit or other hot water device. While some people may have a special cleaner to clean their regular water for drinking purposes, most people are not so fortunate. If you want to clean your water, you have two options: buy bottled water or make your own. With most models, it’s quite easy to make homemade cleaning agents and use them on the unit.
Most units, no matter what type, will come with some instructions. The manufacturer should provide the cleaning agents you need. If not, be sure to follow the directions exactly as they are given. Many manufacturers will provide you with a manual with the purchase of your water maker, so you can learn how to do it right from the start.

When I was cleaning out my sparkler water maker, I used baking soda. I didn’t measure anything, and it seemed like a good thing to be using baking soda to clean it. However, the vinegar and water mix caused it to foam, which is not good for the machine. The froth detergent I was using didn’t help either. In fact, the water bubbled out rather quickly.
So, the next time I wanted to clean my sparkler, I knew what I was looking for, vinegar. I read through the cleaning directions again, and this time, I measured the amount I needed. I started to mix the vinegar and water, and then let it sit for a couple minutes before turning off the heat and cleaning out the clogged unit. Once the machine was clean and everything was running smoothly again, I went about my day as usual.
The problem with cleaning the sparkling water maker this way is that, the vinegar mixture may have been too strong. If you don’t leave it long enough, the mixture could actually damage your heating element. You need to let it sit for a few minutes, and then turn it on hot, let the water run through the system. If you find that the water still bubbles, try reducing the vinegar mix by one-half or using distilled water instead of water. If the problem persists, you may need to contact a professional.
After the water is running through the system properly, you can use hot water to rinse off the soap. This helps remove any residue from the cleaning solution. How do I clean my sparkling water maker if it stops working? If it’s still not functioning properly, the first step is to turn it off, and then remove all the parts from the water tank. Look for a piece of metal or plastic and place it under the water jug to act as a temporary water source while you go about the process of dismantling it.
Use a screwdriver to loosen the valve found on the top of the dispenser, and then tap the bottom to remove the water plug. Using a flathead screwdriver, remove the valve connectors found on the bottom of the system. Now you can remove the rubber sealing ring located at the bottom of the machine. Your sparkling water maker may have other components like a glass door or a wooden door installed within its shell, so carefully check these components as well.
If you are confident enough to tackle this job on your own, then go ahead and do it. Otherwise, you can always purchase the chemical products that most water makers use to clean the water. These chemical cleaners are available at any home improvement store or at major department stores. How do I clean my sparkling water maker? It is really simple once you know what to do!